Publications

Abstract

Purpose

To investigate the practices of repair that exist for users of mobility assistive products in low resource settings, as well as the psychosocial impact that the repair, or non-repair, of these devices has on users’ lives.

Materials and Methods

This article collates data on repair practices and the responses from participants on the topic of repair from studies conducted by the authors across four different low resource settings in Kenya, Uganda, Sierra Leone, and Indonesia. This data was then analyzed to identify the common themes found across geographies.

Results

Three major models of repair practice emerged from the data: “Individual or Informal Repair in the Community”; “Local Initiatives”; and “Specialist AT Workshop Repair”. Additionally, the wider impact on the participants’ lives of “Problems & Concerns with Repair”; “Experiences of Breakages & Frequencies of Repair” and the “Impact of Broken Devices” are explored.

Conclusions

The results of this analysis demonstrate the paramount importance of community-based repair of devices, and how despite this importance, repair is often overlooked in the planning and design of assistive products and services. There is a need to further incorporate and support these informal contributions as part of the formal provision systems of assistive device.

Ben Oldfrey, Cathy Holloway, Julian Walker, Steven McCormack, Bernadette Deere, Laurence Kenney, Robert Ssekitoleko, Helen Ackers & Mark Miodownik (2023) Repair strategies for assistive technology in low resource settings, Disability and Rehabilitation: Assistive Technology, DOI: 10.1080/17483107.2023.2236142

Elastomeric liners are commonly worn between the prosthetic socket and the limb. A number of improvements to the state of the art of liner technology are required to address outstanding problems. A liner that conforms to the residuum more accurately, may improve the skin health at the stump-socket interface. Previous work has shown that for effective thermal management of the socket environment, an active heat removal system is required, yet this is not available. Volume tracking of the stump could be used as a diagnostic tool for looking at the changes that occur across the day for all users, which depend on activity level, position, and the interaction forces of the prosthetic socket with the limb. We believe that it would be advantageous to embed these devices into a smart liner, which could be replaced and repaired more easily than the highly costly and labour-intensive custom-made socket. This paper presents the work to develop these capabilities in soft material technology, with: the development of a printable nanocomposite stretch sensor system; a low-cost digital method for casting bespoke prosthetic liners; a liner with an embedded stretch sensor for growth / volume tracking; a model liner with an embedded active cooling system.

, Additive manufacturing techniques for smart prosthetic liners, Medical Engineering & Physics, Volume 87, 2021, Pages 45-55, ISSN 1350-4533, https://doi.org/10.1016/j.mede....

Humanitarian coordination systems increasingly recognize and aim to respond to the needs of people with disabilities within populations affected by crises, spurred on by the UN Convention on the Rights of Persons with Disabilities (CRPD) which was adopted in 2006. Many agencies state their aim to meet the requirements of the CRPD using a “twin track” approach: ensuring the inclusion of people with disabilities in mainstream provision, alongside targeted support for their needs, which may include the need for Assistive Technology (AT). However, there is very little evidence of AT provision in humanitarian settings, which is a specific and urgent need for many people including the elderly and people with disabilities, and an implicit requirement of Article 11 of the CRPD and World Health Assembly resolution on improving access to assistive technology. There is also little evidence of effective mechanisms for AT provision in humanitarian settings. This is despite high and growing levels of unmet AT need in crises, and despite the legally binding requirement in the CRPD to provide AT for those who need it. AT provision faces unique challenges in humanitarian settings. This paper discusses the evidence available in the literature for the scale and quality of AT provision interventions in crises, and what is known about the challenges and facilitators of provision. We conducted a search of the academic literature and retained literature that reported on any form of AT provision following crisis, where international humanitarian response was in place, published in English between January 2010 and June 2020. We found very few examples in that academic literature of systematic and coordinated AT provision at the acute stage of crisis, and even less in the preparedness and post-acute stages. However, it is difficult to assess whether this is the result of insufficient academic attention or reflects a lack of provision. The small body of academic literature that describes AT provision in humanitarian settings paints a picture of small-scale provision, specialized to single types of impairments, and delivered by predominantly by NGOs. We also conducted a search of the gray literature, using the same inclusion criteria, in two countries: Afghanistan and South Sudan (case studies forthcoming). This gray literature provided supplementary evidence of the types of AT providers and AT provision available in those protracted crises. There are very few examples of how AT services can be scaled up (from a very low baseline) and maintained sustainably within a strengthened health system. The literature also describes more examples of provision of assistive products for mobility over assistive products for other impairments. If the paucity of literature on AT provision in humanitarian settings is a reflection of the scale of provision, this implies a deficiency in humanitarian response when it comes to providing people with AT needs with the essential products and services to which they have a right, and which will enable their access to basic, life-saving assistance. We conclude by providing recommendations for urgent actions that the AT and humanitarian community must take to fill this critical gap in the provision of essential products and services for a potentially marginalized and excluded group.

Golnaz Whittaker, Gavin Adam Wood, Giulia Oggero, Maria Kett & Kirstin Lange (2021) Meeting AT needs in humanitarian crises: The current state of provision, Assistive Technology, 33:sup1, S3-S16, DOI: 10.1080/10400435.2021.1934612

From multiple studies conducted through the FCDO AT2030 Programme, as well as key literature, we examine whether Assistive Technology (AT) provision models could look towards more sustainable approaches, and by doing this benefit not only the environment, but also address the problems that the current provision systems have. We show the intrinsic links between disability inclusion and the climate crisis, and the particular vulnerability people with disabilities face in its wake. In particular, we discuss how localised circular models of production could be beneficial, facilitating context driven solutions and much needed service elements such as repair and maintenance. Key discussion areas include systems approaches, digital fabrication, repair and reuse, and material recovery. Finally, we look at what needs be done in order to enable these approaches to be implemented. In conclusion, we find that there are distinct parallels between what AT provision models require to improve equitable reliable access, and strategies that could reduce environmental impact and bring economic benefit to local communities. This could allow future AT ecosystems to be key demonstrators of circular models, however further exploration of these ideas is required to make sense of the correct next steps. What is key in all respects, moving forward, is aligning AT provision with sustainability interventions.

Oldfrey, B.; Barbareschi, G.; Morjaria, P.; Giltsoff, T.; Massie, J.; Miodownik, M.; Holloway, C. Could Assistive Technology Provision Models Help Pave the Way for More Environmentally Sustainable Models of Product Design, Manufacture and Service in a Post-COVID World? Sustainability 2021, 13, 10867. https://doi.org/10.3390/su1319...

It is essential to understand the strategies and processes which are deployed currently across the Assistive Technology (AT) space toward measuring innovation. The main aim of this paper is to identify functional innovation strategies and processes which are being or can be deployed in the AT space to increase access to AT globally. We conducted a scoping review of innovation strategies and processes in peer-reviewed literature databases and complemented this by identifying case studies demonstrating innovation strategies. The review includes WHO world region, publication year, AT type and a sector analysis against the Systems-Market for Assistive and Related Technologies Framework. We analyzed the case studies and interviews using thematic analysis. We included 91 papers out of 3,127 after review along with 72 case studies. Our results showed that product innovations were more prevalent than provision or supply innovations across papers and case studies. Case studies yielded two themes: open innovation (OI); radical and disruptive innovation. Financial instruments which encourage OI are needed and we recommend pursuing OI for AT innovation. Embedding AT within larger societal missions will be key to success governments and investors need to understand what AT is and their translational socioeconomic value.

Catherine Holloway, Dafne Zuleima Morgado Ramirez, Tigmanshu Bhatnagar, Ben Oldfrey, Priya Morjaria, Soikat Ghosh Moulic, Ikenna D. Ebuenyi, Giulia Barbareschi, Fiona Meeks, Jessica Massie, Felipe Ramos-Barajas, Joanne McVeigh, Kyle Keane, George Torrens, P. V.M. Rao, Malcolm MacLachlan, Victoria Austin, Rainer Kattel, Cheryl D Metcalf & Srinivasan Sujatha (2021) A review of innovation strategies and processes to improve access to AT: Looking ahead to open innovation ecosystems, Assistive Technology, 33:sup1, 68-86, DOI: 10.1080/10400435.2021.1970653